Configuring lldp settings for ports in batch – H3C Technologies H3C WX5500E Series Access Controllers User Manual

Page 223

213

Item Description

DOT1 TLV
Setting

Port VLAN ID

Select the box to include the PVID TLV in transmitted LLDPDUs.

Protocol VLAN ID

Select the box to include port and protocol VLAN ID TLVs in transmitted
LLDPDUs and specify the VLAN IDs to be advertised.
If no VLAN is specified, the lowest protocol VLAN ID is transmitted.

VLAN Name

Select the box to include VLAN name TLVs in transmitted LLDPDUs, and
specify the VLAN IDs to be advertised.
If no VLAN is specified, the lowest VLAN carried on the port is

advertised.

DOT3 TLV
Setting

Link Aggregation

Select the box to include the link aggregation TLV in transmitted
LLDPDUs.

MAC/PHY
Configuration/Status

Select the box to include the MAC/PHY configuration/status TLV in
transmitted LLDPDUs.

Maximum Frame Size

Select the box to include the maximum frame size TLV in transmitted
LLDPDUs.

Power via MDI

Select the box to include the power via MDI TLV and power stateful
control TLV in transmitted LLDPDUs.

MED TLV
Setting

LLDP-MED
Capabilities

Select the box to include the LLDP-MED capabilities TLV in transmitted
LLDPDUs.

Inventory

Select the box to include the hardware revision TLV, firmware revision
TLV, software revision TLV, serial number TLV, manufacturer name TLV,

model name TLV and asset ID TLV in transmitted LLDPDUs.

Network Policy

Select the box to include the network policy TLV in transmitted LLDPDUs.

Extended
Power-via-MDI

Capability

Select the box to include the extended power-via-MDI TLV in transmitted
LLDPDUs.

Emergency Number

Select the box to encode the emergency call number in the location
identification TLV in transmitted LLDPDUs and set the emergency call

number.

Address

Select Address to encode the civic address information of the network
connectivity device in the location identification TLV in transmitted
LLDPDUs. In addition, set the device type which can be a switch or

LLDP-MED endpoint, country code, and network device address.
When you configure the network device address, select the address

information type from the list, enter the address information in the field
below, and click Add next to the field to add the information to the

address information list below. To remove an address information entry,

select the entry from the list, and click Delete. The civic address
information can include language, province/state, country, city, street,

house number, name, postal/zip code, room number, post office box,

and, if necessary, additional information.

Network Device
Address

Configuring LLDP settings for ports in batch

Select Network > LLDP from the navigation tree.
By default, the Port Setup tab is displayed.