H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 14)

4
Item Description
Configure IPv4
address
DHCP
Configure how the VLAN interface obtains an IPv4 address:
• DHCP—Obtain an IP address through DHCP. This option is not
supported.
• BOOTP—Obtain an IP address through BOOTP. This option is not
supported.
• Manual—Manually specify an IPv4 address and the mask length.
BOOTP
Manual
IPv4
address Specify an IPv4 address and the mask length for the VLAN interface.
Dotted decimal notation is also allowed for the mask length field.
These two fields are configurable if Manual is selected.
MaskLen
Configure IPv6
link-local address
(The device does
support IPv6.)
Auto
Configure how the VLAN interface obtains an IPv6 link-local address.
• Auto—Automatically generate a link-local address based on the
link-local address prefix (FE80::/64) and the link layer address of the
interface.
• Manual—Manually assign an IPv6 link-local address to the interface.
Manual
IPv6
address
Specify an IPv6 link-local address for the VLAN interface.
This field is configurable if you select Manual. The address prefix must be
FE80::/64.
Finishing configuration wizard
After finishing the management IP address configuration, click Next.
The page displays your configurations. Review the configurations and if you want to modify the settings
click Back to go back to the page. Click Finish to confirm your settings and the system performs the
configurations.