H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 124)

114
b. Select the box of Enable SNMP Trap.
c. Click Apply.
6. Configure a target host SNMP traps:
a. On the Trap tab page, click Add.
The page for adding a target host of SNMP traps appears.
Figure 117 Adding a trap target host
b. Select the IPv4/Domain option, enter 1.1.1.2 in the following field, enter user1 in the Security
Name field, select v3 from the Security Model list, and select Auth/Priv from the Security Level
list.
c. Click Apply.
Configuring the NMS
IMPORTANT:
The configuration on NMS must be consistent with that on the agent. Otherwise, you cannot perform
corresponding operations.
To configure the NMS:
1. Specify the SNMP version for the NMS as v3.
2. Create an SNMP user user1.
3. Enable both authentication and privacy functions
4. Use MD5 for authentication and DES56 for encryption.
5. Set the authentication key to authkey and the privacy key to prikey.
For more information about configuring the NMS, see the NMS manual.
Verifying the configuration
Verify that the NMS can access and set some MIB variables on the AC.
Shut down and bring up an idle interface on the AC, and verify that the NMS can receive the link traps
from the AC.