H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 112)

102
3. Click Add.
The Add SNMP Group page appears.
Figure 98 Creating an SNMP group
4. Configure SNMP group, as described in Table 37 .
5. Click Apply.
Table 37 Configuration items
Item Description
Group Name Set the SNMP group name.
Security Level
Select the security level for the SNMP group:
• NoAuth/NoPriv—No authentication no privacy.
• Auth/NoPriv—Authentication without privacy.
• Auth/Priv—Authentication and privacy.
IMPORTANT:
For an existing SNMP group, its security level cannot be modified.
Read View Select the read view of the SNMP group.
Write View
Select the write view of the SNMP group.
If no write view is configured, the NMS cannot perform the write operations to all MIB
objects on the device.
Notify View
Select the notify view of the SNMP group, that is, the view that can send trap messages.
If no notify view is configured, the agent does not send traps to the NMS.
ACL
Associate a basic ACL with the group to restrict the source IP address of SNMP packets,
that is, you can configure to allow or prohibit SNMP packets with a specific source IP
address, so as to restrict the intercommunication between the NMS and the agent.
Configuring an SNMP user
1. From the navigation tree, select Device > SNMP.