H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 116)

106
Table 39 Configuration items
Item Description
Destination IP Address
Set the destination IP address.
Select the IP address type: IPv4/domain name or IPv6, and then enter the
corresponding IP address or domain name in the field according to the IP address
type.
The device does not support IPv6 addresses.
Security Name
Set the security name, which can be an SNMPv1 community name, an SNMPv2c
community name, or an SNMPv3 user name.
UDP Port
Set UDP port number.
IMPORTANT:
The default port number is 162, which is the SNMP-specified port used for receiving
traps on the NMS. Generally (such as using IMC or MIB Browser as the NMS), you can
use the default port number. To change this parameter to another value, you need to
make sure that the configuration is the same with that on the NMS.
Security Model
Select the security model, that is, the SNMP version. Make sure that the SNMP
version is the same with that on the NMS; otherwise, the NMS cannot receive any
trap.
Security Level
Set the authentication and privacy mode for SNMP traps when the security model is
selected as v3. The available security levels are: no authentication no privacy,
authentication but no privacy, and authentication and privacy.
When the security model is selected as v1 or v2c, the security level is no
authentication no privacy, and cannot be modified.
Displaying SNMP packet statistics
From the navigation tree, select Device > SNMP.
The page for displaying SNMP packet statistics appears.