H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 118)

108
Figure 105 Configuring the SNMP agent
b. Select the Enable option, and select the v1 and v2 options.
c. Click Apply.
2. Configure a read-only community:
a. Click the Community tab.
b. Click Add.
The Add SNMP Community page appears.
Figure 106 Configuring an SNMP read-only community
c. In the Community Name field, enter public.
d. From the Access Right list, select Read only.
e. Click Apply.
3. Configure a read and write community:
a. On the Community tab page, click Add.
The Add SNMP Community page appears.