EXP Computer C4077-90960 - Manual (Page 396)

Configuring Apple EtherTalk Phase Parameter
To configure EtherTalk parameters:
1 If you do not want to configure the phase parameter, Press [On Line] .
2 Press [Item] . CFG ETALK=NO * appears.
3 Press [+] . CFG ETALK=YES appears.
4 Press [Select] . CFG ETALK=YES * appears.
5 Press [Item] . Phase=2 * appears.
6 Press [+] to change the phase parameter. Phase=1 appears.
7 Press [Select] to save the new value. Phase=1 * appears.
8 Press [On Line] . You may want to configure the AppleTalk name and assign
a preferred EtherTalk Zone.
9 After completing this guide refer to the HP JetDirect Interface
Configuration Guide for further configuration instructions on using the HP
LaserJet Utility.
B
I/O Information
I/O Information B-9