EXP Computer C4077-90960 User Manual
Page 266
Message
Error
Log
Category/
Message
Description
Recommended
Action
LOAD TRAY X or LOAD
ENV FEEDER
type> Attendance The printer received a request for a media Load the indicated tray with the Note: If paper is loaded when the POWER SAVE , it may not be recognized. Open and READY mode. MANUAL FEED TRAY 1 Attendance The printer received a request for a media Load the correct media in Tray 1. [Online] so the printer will use that media. Note: If paper is loaded when the POWER SAVE , it may not be recognized. Open and READY mode. MOPY XX OF Y from Tray n Status This message indicates the progress of the No action required. OFFLINE Status The printer is offline and cannot receive data. Press [Online] . OUT OF STAPLES Attendance The staple cartridge is empty. Staples are Replace the staple cartridge. OUTPUT DEVICE Attendance One of the printer’s interlock switches is not 2. The stapler’s top cover is open. Two Ensure the mailbox is installed Table 7-5 Printer Control Panel Messages (continued) 7 Troubleshooting Troubleshooting 7-29
Required
type and size that is not currently installed in
the printer.
correct media, or override the
media type and size through the
printer’s Control Panel for that
print job.
printer is in
close the affected source when
printer is in
Required
type and size manually fed from Tray 1.
If the correct media is already
loaded, press
printer is in
close the affected source when
printer is in
current job.
Required
detected by a photosensor and flag located
beneath the staple cartridge access slot.
Inserting a cartridge with staples pushes
down this flag.
NOTE: The stapler will retain
some staples; do not remove
them. Remove the cartridge.
Verify that the flag beneath the
staple cartridge slot moves freely.
If it is damaged, replace the
stapler’s top cover. Replace the
Stapler Assembly.
DELIVERY PATH OPEN
Required
set properly. This message displays for one
of two reasons:
1. An external output device, such as the
Multi-Bin Mailbox, is disrupting the paper
path. Switch SW1, the interlock switch, is not
depressed (callout 3, Figure 7-12).
interlock switches detect whether the
stapler’s top cover is closed (refer to Figure
5-21).
tightly against the printer
(especially at the top of the
mailbox). Carpeting and/or
uneven flooring may cause the
top of the mailbox to move away
from the printer, which causes this
error to occur. Verify that Switch
SW1 is working properly (callout
3, Figure 7-12).
Close the stapler’s top cover. The
printer will reset. Verify that the
switches in the stapling unit are
correctly wired and functional.
Perform continuity checks with
the switches.