EXP Computer C4077-90960 User Manual
Page 394
Configuring Novell NetWare Frame Type Parameters.
Normally selecting a NetWare frame type is not required. The HP
JetDirect card automatically selects a NetWare frame type, and only when
this selection is incorrect do you have to set the NetWare frame type
through the HP LaserJet 5Si MX control panel. The NetWare frame type is
displayed on the self test page.
To manually configure Novell NetWare parameters:
1
Press
[Item]
until CFG NOVELL=NO * appears.
2
Press
[+]
until CFG NOVELL=YES * appears.
3
Press
[Select]
. CFG NOVELL=YES * appears.
4
Press
[Item]
. FRAME=AUTO * appears.
5
To configure the Novell NetWare protocol, Press
[+]
to select one of these
frame types:
6
Press
[Select]
to save the selection. An asterisk * appears.
7
If other protocols will be used, continue with the next section. Otherwise,
skip to “Disable Network Protocols” at the end of this appendix.
Frame Type
Description
AUTO (default)
All listed Novell frame types will be allowed.
EN_8023
Limit frame types to IPX over IEEE 802.3 frames. All
others will be counted and discarded.
EN_II
Limit frame types to IPX over Ethernet II frames. All
others will be counted and discarded.
EN_8022
Limit frame types to IPX over IEEE 802.2 frames. All
others will be counted and discarded.
EN_SNAP
Limit frame types to IPX over SNAP with Ethernet
frames. All others will be counted and discarded.
Table B-1
Novell NetWare Frame Types on an HP JetDirect Ethernet Card
B
I/O Information
I/O Information B-7