EXP Computer C4077-90960 - Manual (Page 219)

Metallic Tape and Housing Assembly
1 Remove all of the paper bins, and the blind cover (see Figure 6-86).
2 Lower the Delivery Head to the bottom of the frame.
3 Release the tape retainer by pushing the tab (see Figure 6-79, callout 1).
4 Carefully rewind the tape into its housing. Do not allow the tape to freely
snap back into the housing (see Figure 6-80, callout 2).
5 Remove the tape housing by releasing the retaining tabs (Figure 6-81,
callout 3) and rotating it upward.
To Reinstall:
1 Replace the tape housing by inserting the top of the housing into position
and snapping the housing down into place. Make sure that the tape is in
direct contact with the Transport Belt by routing it underneath the small
plastic guide.
2 Insert the top end of the tape into its retainer slot and gently push it
upward to engage the retainer tab. Before replacing the tape holder, make
sure that the tape is in direct contact with the Transport Belt.
6-92 Removal and Replacement