Top cover assembly – EXP Computer C4077-90960 User Manual
Page 234
Top Cover Assembly
1
Remove the Stapling Unit Assembly (see Figure 6-91).
2
Open the Top Cover Assembly and remove the Back Plate (see Figure 6-92).
3
Unplug the ground and signal cables from the right side of the Stapling
Unit Controller board, being careful to keep them in the cable holder.
4
On each side of the assembly, pull the hinge to release the (2) posts from the
retaining notches (see Figure 6-97).
To Reinstall:
C a u t i o n
Keep the Top Cover Assembly open while reconnecting the cables. Cable
damage could occur the next time the cover is opened if the cables are
reinstalled too tightly.
Figure 6-97
6
Removal and
Replacement
Removal and Replacement 6-107