EXP Computer C4077-90960 User Manual
Page 278
Message
Error
Log
Category/
Message
Description
Recommended
Action
13.x PAPER JAM
(Continued)
13.13
13.14
13.10.03
through
13.13.03
Stapler Assembly Errors
13 = FUSER ACCORDION JAM
14 = PRINTER COULD NOT AUTO EJECT
PAPER
This group of errors are related to
the third device on in the C-Link
daisy chain (see Figure 7-6); in
the supported configuration this
should be the Staple Assembly .
The known individual error log
messages are documened in this
Reference Table in numerical
order, refer to the errorlog column
of this table.
Fusing Assembly related paper
jams. Inspect paper path before
and after the Fusing Assembly.
Inspect entire paper path for
paper or debris (refer to Figure
7-16).
13.11 PAPER JAM
Error
Message
13.17.11
A paper jam occurred at the Vertical Transfer
Assembly entrance. Paper did not reach
entry sensor (PS31) on time. If the feed
rollers are not working properly, the paper will
not advance or it will arrive at sensor PS32
late (see Figure 7-14).
Verify that PS31 and PS32
sensor flags are not blocked and
that the sensors are free of dust
and debris. Using the Paper Path
Test, initiate a print job using Tray
4 as the paper input source.
Open the Transfer Door, then
override PS35 (refer to Figure
7-15). Ensure the feed rollers are
advancing paper. If the rollers do
not rotate, verify that the following
Tray 4 connectors are secure:
Main Drive Assembly (callout 1 in
Figure 6-56), Pickup Assembly
(callouts 2 and 3 in Figure 6-59),
Controller PCA (callout 1 in Figure
6-58), Power Supply (callout 1 in
Figure 6-61). If the problem
persists, replace the Tray 4
Pickup Assembly. If the rollers
drop down and rotate but do not
advance the paper, replace the
feed rollers.
NOTE: The customer replaces
the feed rollers during 350K User
Maintenance (250K images with
HP LaserJet 5Si Heavy Media
printers). Replace the Paper
Pickup Assembly.
Table 7-5
Printer Control Panel Messages (continued)
7
Troubleshooting
Troubleshooting 7-41