EXP Computer C4077-90960 - Manual (Page 214)

Jam Access Door Assembly
1 Remove the left and right covers (see Figure 6-65).
2 Remove the Delivery Head Position Motor (see Figure 6-82).
3 Remove all paper bins and the blind cover (see Figure 6-86).
4 Release the upper end of the Metallic Tape (see Figure 6-79).
5 Release (2) retaining springs (Figure 6-74, callout 1).
6 From the front of the unit, remove (1) e-clip from the right end of the shaft
(Figure 6-75, callout 2).
C a u t i o n Use caution when removing the e-clip because the clip might slip and shoot
towards you or another person.
N o t e Before removing the Jam Access Door six-sided shaft, note the position of
the plastic retainer that holds the metallic tape located at the center of the
door. It must be replaced on the shaft in the same position for proper paper
movement.
7 From the front of the unit, support the door assembly while sliding the shaft
to the left until it is clear of the frame. The retaining springs and tape
retainer will fall free.
8 Release the upper ends of the Paper Guide Strings (Figure 6-76, callout 3)
from the assembly.
To Reinstall:
1 Attach the upper ends of the Paper Guide Strings to the door assembly
before installing it into the frame.
2 Make sure that the retaining springs and the tape retainer are properly
positioned as you insert the shaft into the frame.
3 Make sure that the retaining springs, e-clip, and copper grounding plate
are properly replaced on the shaft in the same position in which they were
removed.
6
Removal and Replacement
Removal and Replacement 6-87