RLE LD5200 V.2.3 - Manual (Page 65)

rletech.com LD5200 User Guide 65
4 Web Interface
Throughout the mapping process, you will use a set of crosshairs to designate the location of
your mapped points. The LD5200 firmware interprets the area directly in the center of the
crosshairs as your reference point. Therefore, the point you’re mapping appears on the map
wherever the center of the crosshairs is located when you click the mouse to designate the
object’s location.
Figure 4.18 Mapping Crosshairs - Reference Point
When mapped, reference points appear on the map as follows:
Figure 4.19 Map Key
1 Click the Map Alarm Coordinates - Graphical link on the Map Configuration web page.
Figure 4.20 Graphical Mapping Link
2 The Graphical Mapping link takes you to a view of your map image. This is where you’ll
designate the physical locations of your mapped coordinates. In the “Enter a distance” box
Point Map Display
Leak detected Red square in the leak’s location.
The square does not appear on the map until
a leak is detected.