RLE LD5200 V.2.3 - Manual (Page 23)

rletech.com LD5200 User Guide 23
2 Installation
4 When the LD5200 powers up, diagnostics are performed. The program code is verified.
Once the diagnostics are complete, the LCD displays the Main Menu. No alarm should be
present. If an alarm is present, verify all connections and consult Appendix D,
“Troubleshooting” on page 109.
2.6 Configure Communications
Use the LCD touch screen on the front of the LD5200 to configure communications.
IMPORTANT Consult your IT department before performing these steps. If you intend to change the IP
Address and/or Subnet Mask, obtain appropriate addresses from your IT department.
LD5200 default IP address: 10.0.0.188
LD5200 default subnet mask: 255.255.255.0
LD5200 default gateway: 10.0.0.1
2.6.1 Access the Configuration Menu
1 Push the Setup button on the LD5200’s LCD.
2 You’ll be prompted to enter a password. By default, there is no password on the LD5200.
To continue past the login screen, leave the password field blank and press the Enter button
( ).
You can establish an LCD password through either the LCD interface ( “Leak Settings” on
page 37 ) or the web interface (Chapter 4, “Leak” on page 50).
3 You’ll see the LD5200 Setup Menu. Press the Down button until the System Settings option
is highlighted in blue. Press the Select button to access the System Setup Menu.
4 Push the Down button until the IP address is highlighted. By default, the IP address is
10.0.0.188. Press the Select button to change the IP address.
5 Use the backspace button ( ) to delete the current IP address. Enter the new IP address
for the unit, as provided by your Network Administrator. Press the Enter button to apply the
new IP Address.
6 Scroll down to the Net Mask, and use the same method to edit the Subnet Mask information
as necessary.