RLE LD5200 V.2.3 - Manual (Page 16)

16 LD5200 User Guide 800.518.1519
2 Installation
2.2 Mount the LD5200
The LD5200 is a wall mounted device. Using the wall mount kit (included), mount the device
in a convenient location.
Figure 2.1 LD5200 Wall Mounting Kit
Once the unit is mounted on the wall, run conduit to the device to support your cabling needs.
2.3 Establish Physical Connections
The connectors for the LD5200 are accessible from the inside of the enclosure. Remove the
knock-outs on the bottom and top of the enclosure as necessary to accommodate conduit and
cabling.
The LD5200 is built with two circuit boards:
♦ The display board is mounted on the inside of the LD5200’s door, and is connected to the
main board with a multi-wire connector. The display is a color touch screen that enables
configuration and management from the front panel.
♦ The main board is mounted inside the main compartment of the enclosure. A power supply
and power switch are also mounted in this main compartment.
The connectors on the main board, shown in Figure 2.2 , are labeled TB1 through TB7 and P1
through P3. Switches are labeled SW1 through SW3 and the Status LED is labeled DS1. The
image of the board has been rotated to accommodate labels.