RLE LD5200 V.2.3 - Manual (Page 56)

56 LD5200 User Guide 800.518.1519
4 Web Interface
4.3.4 Slave Zones
If you have designated controllers on the Slave Configuration page, then use this page to label
the slave zone(s). Your available labeling and configuration options will change depending on
the type of device, and how you’re obtaining the information. If you are pulling in data via
BACnet IP, the fields will display but will be read only. If there are no slave devices
configured on the unit, you will be rerouted back to the main Configuration page.
Figure 4.8 Slave Zone Configuration Page, Distance-Read via Modbus
.
Figure 4.9 Slave Zone Configuration Page, Zone
Option Description
Jump to Unit Use this drop down menu to access additional devices.
Zone # A fixed number used to designate the controller, as configured on
the Slave Configuration menu.
Label Type a descriptive label for the controller, 30 characters or less.
End Distance For distance-read systems, the distance reading at the end of that
virtual zone.
Table 4.4 LDZ/Slave Zone Label Configuration Options