Measurement Computing ADAC-LVi - Manual (Page 90)

Chapter 2 Signal Conditioning VIs
ADAC LabVIEW VI 84
ADAC TC Lin Buff (Convert Thermocouple Buffer)
This VI Converts the specified thermocouple Source Voltages input array into the
specified temperature units.
Source Voltage(s) Source Voltage(s) is a one-dimensional array containing the input
data in volts to be converted into temperature.
Thermocouple Type (0:BNBS) Thermocouple Type is a numeric value that specifies the
NBS thermocouple polynomial equation for the conversion. The available options are:
0:BNBS B-type thermocouple
1:KNBS K-type thermocouple
2:SNBS S-type thermocouple
3:TNBS T-type thermocouple
4:JNBS J-type thermocouple
5:RNBS R-type thermocouple
6:ENBS E-type thermocouple
The default Thermocouple Type is 0:BNBS
Units (0:celsius) Units specifies the desired temperature units for the conversion. The
available options are:
0:Celcius Celsius degree
1:Fahrenheit Fahrenheit degree
2:Kelvin Kelvin degree
3:Rankine Rankine
The default Units is 0:Celcius
error in (no error) Error in describes error conditions occurring before this VI executes.
This cluster defaults to no error.
Temperature(s) Temperature(s) is a one-dimensional array containing the converted
data in the specified temperature units.
error out Error out contains error information. If the error in cluster indicated an error,
the error out cluster contains the same information. Otherwise, error out describes the
error status of this VI.