Measurement Computing ADAC-LVi - Manual (Page 167)

Chapter 2 Input Config Library
ADAC LabVIEW VI 161
ADAC Input Config Library
•
ADAC Set Input Config
•
ADAC Get Input Config
ADAC Set Input Config
This VI sets the hardware input configuration of the device.
Device Handle (0) Device Handle is a numeric value that is used to identify the device
subsystem. The default Device Handle is 0.
INPUT CONFIG (DIFF:0) INPUT Config is a numeric value that sets the hardware
input configuration of the device. The available options are:
0:DIFFERENTIAL Differential inputs
1:SINGLE-ENDED Single-ended inputs
2:PSEUDO-DIFFERENTIAL Pseudo-Differential inputs
The default Input Config is 0:DIFFERENTIAL
error in (no error) Error in describes error conditions occurring before this VI executes.
This cluster defaults to no error.
Device Handle out Device Handle out contains the value of Device Handle in.
error out Error out contains error information. If the error in cluster indicated an error,
the error out cluster contains the same information. Otherwise, error out describes the
error status of this VI.