Measurement Computing ADAC-LVi - Manual (Page 127)

Chapter 2 Burst Config Library
ADAC LabVIEW VI 121
ADAC Set Burst Rate
This VI sets the hardware burst rate of the Device. The rate can be specified in hertz or
tics.
Device Handle (0) Device Handle is a numeric value that is used to identify the device
subsystem. The default Device Handle is 0.
Units (HERTZ:0) Units is a numeric value that specifies base units in which the Burst
Rate parameter is specified. The available options are:
0:HERTZ Rate is specified in units of hertz
1:TICS Rate is the divisor to the Burst clock source
If TICS is chosen, the Burst Rate parameter is usually set as divisor of the Burst Source
clock.
The default Unit is 0:HERTZ
Burst Rate (100) Burst Rate is a double value that specifies the rate at which burst
clocks occur.
error in (no error) Error in describes error conditions occurring before this VI executes.
This cluster defaults to no error.
Device Handle out Device Handle out contains the value of Device Handle in.
error out Error out contains error information. If the error in cluster indicated an error,
the error out cluster contains the same information. Otherwise, error out describes the
error status of this VI.