Measurement Computing ADAC-LVi - Manual (Page 179)

Chapter 2 Device Function Library
ADAC LabVIEW VI 173
$'$& 6HW &\FOH 0RGH FRQW
Device Handle (0) Device Handle is a numeric value that is used to identify the device
subsystem. The default Device Handle is 0.
Cycle Mode (SINGLE_CYCLE:0) Cycle Mode is a numeric value that sets the
software cycle operation mode of the device. The available options are:
0:SINGLE_CYCLE complete acquisition and stop
1:CONTINUOUS_CYCLE repeat acquisition
The default Cycle Mode is 0:SINGLE_CYCLE.
error in (no error) Error in describes error conditions occurring before this VI executes.
This cluster defaults to no error.
Device Handle out Device Handle out contains the value of Device Handle in.
error out Error out contains error information. If the error in cluster indicated an error,
the error out cluster contains the same information. Otherwise, error out describes the
error status of this VI.
ADAC Set DTM (Data Transfer Method)
This VI sets the Data Transfer Method of the device. The mode can be SOFTWARE,
DMA, IRQ or C40PORT.