Measurement Computing ADAC-LVi - Manual (Page 160)

Chapter 2 Filter Config Library
ADAC LabVIEW VI 154
ADAC Set Filter Freq
This VI sets the hardware anti-alias filter clock frequency. The rate is specified in hertz.
This VI is used only with ADAC 5508SCi.
Device Handle (0) Device Handle is a numeric value that is used to identify the device
subsystem. The default Device Handle is 0.
Filter Freq. (100) Filter Frequency is a double value that specifies rate at which anti-
alias filter is configured at the factory.
error in (no error) Error in describes error conditions occurring before this VI executes.
This cluster defaults to no error.
Device Handle out Device Handle out contains the value of Device Handle in.
error out Error out contains error information. If the error in cluster indicated an error,
the error out cluster contains the same information. Otherwise, error out describes the
error status of this VI.
ADAC Get Filter Struct
This VI provides access to the device's filter settings. See the associated Filter type
setting VI for a full description of the FILTER STRUCT cluster. This VI is used only
with ADAC 5508SCi.