Measurement Computing ADAC-LVi - Manual (Page 203)

Chapter 2 Trigger Config Library
ADAC LabVIEW VI 197
$'$& *HW 7ULJJHU 6WUXFWXUH FRQ¶W
Trigger Rate Trigger Rate is a double value that specifies rate at which triggers
occur.
Post Sample Count Post Count is a numeric value that sets the number of
samples to be obtained after a trigger has been received. The available range is
device dependent and is verified against the min./max. range specified in the
device's capabilities file.
Post Count is used with ABOUT_TRIG and PRE_TRIG trigger modes.
error out Error out contains error information. If the error in cluster indicated an error,
the error out cluster contains the same information. Otherwise, error out describes the
error status of this VI.