Measurement Computing ADAC-LVi - Manual (Page 54)

Chapter 2 Utility Analog Input VIs
ADAC LabVIEW VI 48
$'$& $, 6HW 7ULJJHU &RQILJ FRQ¶W
Trigger Rate Trigger Rate is the time in seconds(Hertz) the a trigger clock re-
triggers an acquisition. This parameter is used to set rate of an on-board
triggering clock when selected form the Trigger Source setting above.
Post Sample Counts (-1: nochange) Post Sample Counts specifies the number
of samples to be collected after the second trigger occurs. The Trigger Mode
must be set to ABOUT_TRIGGER.
error in (no error) Error in describes error conditions occurring before this VI executes.
This cluster defaults to no error.
Device Handle out Device Handle out contains the value of Device Handle in.
error out Error out contains error information. If the error in cluster indicated an error, the
error out cluster contains the same information. Otherwise, error out describes the error
status of this VI.