Measurement Computing ADAC-LVi - Manual (Page 163)

Chapter 2 Gate Config Library
ADAC LabVIEW VI 157
ADAC Set Gate Level
This VI sets the hardware gating level of the device. The source can be either active_low
or active_high.
Device Handle (0) Device Handle is a numeric value that is used to identify the device
subsystem. The default Device Handle is 0.
Gate Level (ACTIVE_LOW:0) Gate Level is a numeric value that sets the hardware
gate level of the device. The available options are:
0:ACTIVE_LOW Low level gate signal active
1:ACTIVE_HIGH High level gate signal active
The default Gate Level is 0:ACTIVE_LOW
error in (no error) Error in describes error conditions occurring before this VI executes.
This cluster defaults to no error.
Device Handle out Device Handle out contains the value of Device Handle in.
error out Error out contains error information. If the error in cluster indicated an error,
the error out cluster contains the same information. Otherwise, error out describes the
error status of this VI.