Measurement Computing ADAC-LVi - Manual (Page 164)

Chapter 2 Gate Config Library
ADAC LabVIEW VI 158
ADAC Set Software Gate
This VI sets the hardware gate state of the device. The software gate can be either
enabled or disabled.
Device Handle (0) Device Handle is a numeric value that is used to identify the device
subsystem. The default Device Handle is 0.
Software Gate (DISABLED:0) Software Gate is a numeric value that sets the desired
hardware gate state of the device. The available options are:
0:DISABLED The device is stopped
1:ENABLED The device is enabled to run
The default SwGate state is 0:DISABLED
error in (no error) Error in describes error conditions occurring before this VI executes.
This cluster defaults to no error.
Device Handle out Device Handle out contains the value of Device Handle in.
error out Error out contains error information. If the error in cluster indicated an error,
the error out cluster contains the same information. Otherwise, error out describes the
error status of this VI.