Comtech EF Data SNM-1000 - Manual (Page 96)

SNM-1000 Node Control Modem Revision 3
Operation MN/SNM1000.IOM
3–54
3.7.3.7 Queries
The interface can be queried by issuing a valid command without a value at the end. This
will result in the return of the currently set value.
Example (assume a previously sent command as shown):
ICF 70.4567'cr' — sets inbound control IF frequency to 70.4567 MHz.
Now a query:
ICF'cr'
Response from interface:
ICF 70.4567 — inbound control IF frequency is 70.4567 MHz.
3.7.4 Node Address (NA)
This command sets the node number for the remote control channel mode SNM-1000
controller.
3.7.4.1 Command Format
NA 'cr'
Range of 1 to 9999 and must be unique in the network.
Unpredictable results will occur if two nodes are online and both have been
assigned the same node number.
The node number will generally be defined by the provisioning documents that
establish remote sites and circuits.
3.7.4.2 Local Command Responses
node address =