Comtech EF Data SNM-1000 - Manual (Page 157)

SNM-1000 Node Control Modem Revision 3
Remote Control Operation MN/SNM1000.IOM
A–9
A.5 Interface Configuration Commands
Transmit Clock Command:
Response:
Status:
Response:
MC TC_xxx'cr'
TC_xxx'cr''lf']
MC TC_'cr'
TC_xxx'cr''lf'] Where:
xxx = INT (Internal SCT Clock), EXT (External
TX Terrestrial Clock), or SAT (Receive Satellite
Clock).
Transmit Clock Phase Command:
Response:
Status:
Response: MC TCP_xxxx'cr'
TCP_xxxx'cr''lf']
MC TCP_'cr'
TCP_xxxx'cr''lf']
Where:
In TX Burst mode, xxxx = NRM (Normal Clock
Phasing) or INV (Inverted Clock Phasing).
In TX Continuous mode, xxxx = NRM (Normal
Clock Phasing), INV (Inverted Clock Phasing),
or AUTO (Automatic Clock Phasing).
Buffer Clock Command:
Response:
Status:
Response: MC BC_xxx'cr'
BC_xxx'cr''lf']
MC BC_'cr'
BC_xxx'cr''lf']
Where: xxx = INT (Internal SCT Clock), EXT
(External TX Terrestrial Clock), SAT (Receive
Satellite Clock), or REF (External Reference Clock).
Note: In RX Continuous mode only.
Receive Clock Phase Command:
Response:
Status:
Response: MC RCP_xxxx'cr'
RCP_xxxx'cr''lf']
MC RCP_'cr'
RCP_xxxx'cr''lf']
Where: xxxx = NRM (normal clock phasing) or INV
(inverted clock phasing).
Baseband Loopback Command:
Response:
Status:
Response:
MC BBL_xxx'cr'
BBL_xxx'cr''lf']
MC BBL_'cr'
BBL_xxx'cr''lf']
Where: xxx = ON or OFF.