Comtech EF Data SNM-1000 - Manual (Page 105)

SNM-1000 Node Control Modem Revision 3
Operation MN/SNM1000.IOM
3–63
3.7.16.2 Local Command Responses
NOT PRESENT The local channel number does not exist or is disconnected.
DATA
can have the following values:
Modem Model
CiM-550
CiM-300L
CDM-550
CDM-600
SDM-300
SDM-300L2
SDM-300L3
SDM-2020D
SDM-2020M
Code
CiM-550
CiM-300L
CDM-550
CDM-600
SDM-300
SDM-300L2
SDM-300L3
SDM-2020D
SDM-2020M Modem Model
*SDM-100
*SDM-150
*SDM-6000
*SDM-8000
*SDM-9000
*SDM-140
*SDM-155
Code
SDM-100
SDM-150
SDM-6000
SDM-8000
SDM-9000
SDM-140
SDM-155
*Legacy Modem
3.7.17 Modem Command Sequence (MC)
This command permits the use of the User Port to directly communicate with the
specified external traffic modem being controlled by the SNM-1000. Communication
with the control channel modem is through channel 0 and with traffic modems using the
defined channel number.
Refer to Appendix A for some of the M&C remote commands that can be used with this
command.
3.7.17.1 Command Format
MC 'modem command string''cr'
Prefix channel number.
Valid range: 0 through 30.
0 for SNM1000
1 through 30 are for traffic modems attached to an SNM-1000, operating in external
traffic mode.
MC The command string following the 'MC' command is issued directly to the specified
modem. It has the format as shown in the appropriate modem manuals, except that the
leading string through the slash mark (