Comtech EF Data SNM-1000 User Manual
Page 162
SNM-1000 Node Control Modem
Revision 3
Remote Control Operation
MN/SNM1000.IOM
A–14
Demodulator/Decoder
Configuration
Program Status
Status:
Response:
MOM_xxxxxxx'cr'
BERT_xxxx'cr'
DT_xxxx'cr'
DDT_xxx'cr'
DF_nnn.nnnn'cr'
DR_nnnn_mmm.mmm'cr'
DE_xxx'cr'
DDEC_xxx'cr'
RFL_xxx'cr'
IFL_xxx'cr'
SCF_snnnnn'cr' (Note
1)
SWR_nnnnn'cr' (Note
1)
RDA_xxx'cr' (Note
1)
BC_xxx'cr' (Note
1)
RCP_xxxx'cr'
BBL_xxx'cr'
IBP_xxx'cr' (Note
1)
IBS_nnnnn'cr' (Note
1)
RXM_xxxxx'cr'
RSDE_xxx'cr''lf']
Modem Operation Mode
BER Threshold
Demodulator Type
Demodulator Decoder Type
Demodulator Frequency
Demodulator Rate
Descrambler Enable (ON/OFF)
Differential Decoder (ON/OFF)
RF Loopback (ON/OFF)
IF Loopback (ON/OFF)
Sweep Center Frequency
Sweep Width Range
Receive BPSK Data Ordering
Buffer Clock (Source)
Receive Clock Phase
Baseband Loopback
Interface Buffer Programming
Interface Buffer Size
Receive Mode
Reed-Solomon Decoder
This command is used by the M:N
protection switch to collect information
necessary for configuring backup modems.
Notes:
1. Status only returned in Receive
Continuous mode.
Interface
Configuration Status
Status:
Response:
TC_xxx'cr'
TCP_xxxx'cr'
RCP_xxxx'cr'
BBL_xxx'cr'
BC_xxx'cr' (Note
1)
IBP_xxx'cr' (Note
1)
IBS_nnnnn'cr' (Note
1)
RTSM_xxx'cr''lf']
(Note 2)
Transmit Clock (Source)
Transmit Clock Phase
Receive Clock Phase
Baseband Loopback
Buffer Clock (Source)
Interface Buffer Programming
Interface Buffer Size
RTS TX-IF Control Mode
The interface configuration status command
causes a block of data to be returned by the
addressed modem. The block reflects the
current configuration of the interface.
Notes:
1. Status only returned in Receive
Continuous mode.
2. Status only returned in Transmit
Continuous mode.