Abnormal condition responses, Character set, Status lines and flow control – Comtech EF Data SNM-1000 User Manual
Page 150: Message structure, A.2 abnormal condition responses, A.2.1 character set, A.2.2 status lines and flow control, A.2.3 message structure

SNM-1000 Node Control Modem
Revision 3
Remote Control Operation
MN/SNM1000.IOM
A–2
A.2
Abnormal Condition Responses
If a satellite modem receives a message which does not match the established protocol or
cannot be implemented, a negative acknowledgment message is sent in response. The
possible message formats are:
•
(Error message for received parity errors.)
•
(Error message for a recognized command which cannot be implemented or has parameters
which are out-of-range.)
•
(Error message for unrecognizable command or bad command syntax.)
•
(Modem in local error, use the REM command to go to remote mode.)
•
(Error message indicating that the parameter is hardware dependent and may not be changed
remotely.)
A.2.1 Character
Set
The interface responds to ASCII characters in the range of 0x00 to 0x7F. The 8th bit
(most significant) is not generated on the transmit side and is ignored on the receive side.
A.2.2
Status Lines and Flow Control
The interface ignores all status inputs.
A.2.3 Message
Structure
A message is either a command or a response. Each message is made up of three
elements:
• Prefix
• Message body
End character