Comtech EF Data SNM-1000 - Manual (Page 59)

SNM-1000 Node Control Modem Revision 3
Operation MN/SNM1000.IOM
3–17
3.4.1.3.9 INTERFACE:LOOP TIMING
LOOP TIMING
OFF
The SCT output will become phase-locked to the RX satellite clock.
TX and RX data rates must be equal unless the asymmetrical loop timing option is On or
Off.
• Upon entry, the status is displayed.
• Press [↑] or [↓] to make the selection.
• Press [ENTER] to execute the change.
3.4.1.4 CONFIGURATION:SAVE
CONFIGURATION
SAVE
The Configuration Save menu allows programming of configuration parameters into
memory on the M&C. There are five memory locations that may be used to store specific
configuration setups that are used frequently. After changing the configuration
parameters to the desired settings, enter the Configuration Save menu and select memory
location 1 through 5.
Press [ENTER] to execute the save.
3.4.1.5 CONFIGURATION:RECALL
CONFIGURATION
RECALL
The Configuration Recall menu allows the user to recall a previously saved configuration
setup. Upon entry, select memory location 1 through 5 by pressing [
↑] or [↓].
Press [ENTER] to execute the recall.