Comtech EF Data SNM-1000 - Manual (Page 168)

SNM-1000 Node Control Modem Revision 3
Remote Control Operation MN/SNM1000.IOM
A–20
A.8 Stored Faults
Information on stored faults is returned when requested. If no stored fault exists for a given
fault number, the words ‘NO FAULT’ will be returned instead of the normal time/date and
status information.
The following symbols are used to define the stored faults status commands.
• #
Fault number (0 through 9), '0' is the first fault stored.
• hh
Hours in 24-hour format.
• mm Minutes.
• ss Seconds.
• MM Month.
• DD Day.
• YY Year.
Modulator
Stored Faults Command:
Response:
Response:
MC MSF_#'cr'
MSF_# hh:mm:ss
MM/DD/YY'cr'
MOD_xxx'cr'
SYN_xxx'cr'
DCS_xxx'cr'
AGC_xxx'cr''lf']
MSF_# hh:mm:ss
MM/DD/YY'cr'
MOD_xxx'cr'
SYN_xxx'cr'
DCS_xxx'cr'
ICH_xxx'cr'
QCH_xxx'cr'
AGC_xxx'cr''lf']
TX Burst Mode:
Module (OK/FLT).
IF Synthesizer (OK/FLT).
Data Clock Synthesizer (OK/FLT).
AGC Level (OK/FLT).
TX Continuous Mode:
Module (OK/FLT).
IF Synthesizer (OK/FLT).
Data Clock Synthesizer (OK/FLT).
I Channel (OK/FLT).
Q Channel (OK/FLT).
AGC Level (OK/FLT).
Demodulator
Stored Faults
Command:
Response:
MC DSF_#'cr'
DSF_# hh:mm:ss
MM/DD/YY'cr'
MOD_xxx'cr'
CD_xxx'cr'
SYN_xxx'cr'
ICH_xxx'cr'
QCH_xxx'cr'
DSCR_xxx'cr'
BERT_xxx'cr''lf']
RX Continuous Mode:
Demod module (OK/FLT).
Carrier Detect (OK/FLT).
IF Synthesizer Lock (OK/FLT).
I Channel (OK/FLT).
Q Channel (OK/FLT).
Descrambler (OK/FLT).
BER Threshold (OK/FLT).