Comtech EF Data SNM-1000 - Manual (Page 172)

SNM-1000 Node Control Modem Revision 3
Remote Control Operation MN/SNM1000.IOM
A–24
Bulk
Consolidated Status
(continued
Where: 'pn' is the last parameter returned.
Paramete
r
Number
Parameter Name
(Command Reference)
Description
(Note 1)
(Note 1)
(Note 1)
(Note 3)
(Note 2)
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
Transmit Clock Phase
(ref. 'TCP_' command).
Buffer Clock Source
(ref. 'BC_' command).
Receive Clock Phase
(ref. 'RCP_' command).
Baseband Loopback
(ref. 'BBL_' command).
Interface Buffer Programming
(ref. 'IBP_' command).
Interface Buffer Size
(ref. 'IBS_' command).
Modem Operation Mode
(ref. 'MOM_' command).
Modem Remote/Local Mode.
Not valid.
Not valid.
Not valid.
Not valid.
Not valid.
Not valid.
Not valid.
Not valid.
Not valid.
Not valid.
Not valid.
Not valid.
Not valid.
Transmit Mode Selection
(ref. 'TXM_' command).
Modulator Preamble Selection
(ref. 'MPRE_' command).
p35 = n, where 'n' is '0' (NRM), '1' (INV), or '2' (AUTO).
p36 = n, where 'n' is '0' (INT), '1' (REF), '2' (EXT), or '3' (SAT).
p37 = n, where 'n' is '0' (NRM) or '1' (INV).
p38 = n, where 'n' is '0' (OFF) or '1' (ON).
p39 = n, where 'n' is '0' (BITS) or '1' (MS).
p40 = nnnnnn, buffer size in bits or milliseconds.
p41 = n, where 'n' is '1' (TX_ONLY), '2' (RX_ONLY), or '3'
(DUPLEX).
p42 = n, where 'n' is '0' (LOCAL) or '1' (REMOTE).
p56 = n, where 'n' is '1' (BURST) or '2' (CONTINUOUS).
p57 = n, where 'n' is '1' (PREAMBLE) or '2' (PREAMBLE 2).