Comtech EF Data SNM-1000 - Manual (Page 79)

SNM-1000 Node Control Modem Revision 3
Operation MN/SNM1000.IOM
3–37
3.4.5.3.6 INTERFACE:FRAMING STRUCTURE
FRAMING STRUCTURE
T1 FRAMING
STRUCTURE: G.704
E1 FRAMING
STRUCTURE: G.704
Displays the currently selected framing type and structure of the data. This function is used
with the buffer program in ms for plesiochronous buffer slips.
Upon entry, the framing type (T1 or E1) is displayed on Line 1. The framing structure of
each type (None or G.704) is displayed on Line 2. Press [
←] or [→] and [↑] or [↓] to select
framing structure and type. Press [ENTER] to execute the change.
3.4.5.3.7 INTERFACE:RTS TX-IF CNTRL
RTS TX-IF CNTRL
OFF
Programs the modem to allow a Request To Send (RTS) signal to On or Off the output
when data is ready for transmission.
Press[
←], [→], [↑], or [↓] to move the flashing cursor. Press [ENTER] to execute the
change.
3.4.5.3.8 INTERFACE:TX DATA PHASE
TX DATA PHASE
NORMAL
TX data phase relationship. Use this option to select NORMAL or INVERT for the TX
data relationship to the selected TX clock.
Upon entry, press [
↑] or [↓] to make the selection. Press [ENTER] to execute the change.