Comtech EF Data SNM-1000 - Manual (Page 160)

SNM-1000 Node Control Modem Revision 3
Remote Control Operation MN/SNM1000.IOM
A–12
A.6.1 Modem Type Commands
Refer to the following listing for modem type commands.
Transmit Mode
Selection Command:
Response:
Status:
Response: MC TXM_xxxxx'cr'
MC
TXM_xxxxx'cr''lf']
MC TXM_'cr'
MC
TXM_xxxxx'cr''lf']
Where: xxxxx = BURST or CONT (Continuous).
This command configures the modem transmit
side to operate in Burst or Continuous mode.
The is 0 for the remote control
mode SNM-1000.
Receive Mode Selection Command:
Response:
Status:
Response: MC RXM_xxxxx'cr'
MC
RXM_xxxxx'cr''lf']
MC RXM_'cr'
MC
RXM_xxxxx'cr''lf']
Where: xxxxx = CONT (Continuous).
This command configures the modem receive side
to operate in Burst or Continuous mode.
The is 0 for the remote control
mode SNM-1000.
A.7 Configuration Status
Refer to the following listing for configuration status data.
Modulator
Configuration
Status Status:
Response: MC MCS_'cr'
MCS_'cr'
RF_xxx'cr'
MF_nnn.nnnn'cr'
MR_nnnn_mmm.mmm'cr'
AMRA_nnnn_mmm.mmm'cr'
AMRB_nnnn_mmm.mmm'cr'
AMRC_nnnn_mmm.mmm'cr'
AMRD_nnnn_mmm.mmm'cr'
AMRV_nnnn.mmm.mmm'cr'
MPO_snn.n'cr'Modulator
MOP_snnn.n'cr'
SE_xxx'cr'
DENC_xxx'cr'
MT_xxxx'cr'
MET_xxx'cr'
TDA_xxx'cr' (Note
1)
COM_xxx'cr'
TXM_xxxxx'cr'
MPRE_n'cr' (Note
2)
RSEN_xxx'cr''lf'] (Note 1)
RF Output (ON/OFF)
Modulator Frequency
Modulator Rate
Preset A Assignment
Preset B Assignment
Preset C Assignment
Preset D Assignment
Preset V Assignment
Power Offset
Modulator Output Power
Scrambler Enable (ON/OFF)
Differential Encoder (ON/OFF)
Modulator Type
Modulator Encoder Type
Transmit BPSK Data Ordering
Carrier Only Mode (ON/OFF)
Transmit Mode
Modulator Preamble
Reed-Solomon Encoder
The modulator configuration status
command causes a block of data to be
returned by the addressed modem. The
block of data reflects the current
configuration status of the modulator
module.
Notes:
1. Status only returned in Transmit
Burst mode.
2. Status only returned in Transmit
Continuous mode.