Comtech EF Data SNM-1000 - Manual (Page 165)

SNM-1000 Node Control Modem Revision 3
Remote Control Operation MN/SNM1000.IOM
A–17
A.7.2 Error Performance Status
Raw BER Status:
Response:
MC RBER_'cr'
RBER_xm.mE-ee'cr''lf']
Where:
x = < or > (data modifier to indicate that
the error rate is less than or greater
than the returned value).
m.m = 1.0 to 9.9 (error rate mantissa).
ee = 1 to 99 (error rate exponent).
Notes:
1. The 'x' (< or >) parameter is only
returned if the error rate has
exceeded the computational
resolution of the system.
2. 'No Data' is returned if the error rate
cannot be calculated.
3. 'Sampling' is returned if not enough
data is currently available to
calculate the error rate.
Corrected BER Status:
Response:
MC CBER_'cr'
CBER_xm.mE-ee'cr''lf']
Where:
x = < or > (data modifier to indicate that
the error rate is less than or greater
than the returned value).
m.m = 1.0 to 9.9 (error rate mantissa).
ee = 1 to 99 (error rate exponent).
Notes:
1. The 'x' (< or >) parameter is only
returned if the error rate has
exceeded the computational
resolution of the system.
2. 'No Data' is returned if the error rate
cannot be calculated.
3. 'Sampling' is returned if not enough
data is currently available to
calculate the error rate.