Comtech EF Data SNM-1000 - Manual (Page 109)

SNM-1000 Node Control Modem Revision 3
Operation MN/SNM1000.IOM
3–67
3.7.20 Initiate Multipoint Data Call (MI)
This command initiates a multipoint data call on the specified channel. The NMS reports
call status using the CS unsolicited response.
3.7.20.1 Command Format
MI
'cr'
Prefix channel number.
Valid range: 1 through 30.
1 through 30 are for traffic modems attached to an SNM-1000, operating in
external traffic mode.
MI Initiate MultiPoint Data Call
Destination data channel address (phone number).
Max. length: 32 characters.
Valid characters: '1', '2', '3', '4', '5', '6', '7', '8', '9', '0', '*', '#', 'A', 'B', 'C', 'D', '-',
'(' or ')'
Note: The '-' and '('or')' characters are not part of the number and are used to
increase readability. They are stripped out and not passed to the NMS.
and
Data rates, defined in kbps.
Step size: 1 bit/s.
Maximum value: 8192.000 kbps.
Examples: 64 is 64 kbps, 64.001 is 64.001 kbps, 1024.1 is 1.0241 Mbit/s, etc.
Note: The decimal point is not required and the entered number is rounded to
the nearest 1 bit/s value.