Interface buffer size, A.5.1 interface buffer size – Comtech EF Data SNM-1000 User Manual
Page 158
SNM-1000 Node Control Modem
Revision 3
Remote Control Operation
MN/SNM1000.IOM
A–10
A.5.1 Interface
Buffer
Size
Buffer size programming is supported in two formats: bits or ms. The selected format
shall be chosen using the buffer programming command (
IBP_
), shown in the following
listing.
Interface Buffer Size
(bit format)
Command:
Response:
Status:
Response:
Where: nnnnn = 64 to 65536, in 16-bit
increments.
Note: In RX Continuous mode only.
Interface Buffer Size
(ms format)
Command:
Response:
Status:
Response:
Where: nn = 0 to 50 (buffer size in ms).
Note: In RX Continuous mode only.
Interface Buffer Center
Command:
Response:
Note: In RX Continuous mode only.
Interface Buffer Programming
Command:
Response:
Status:
Response:
Where: xxx = bits or ms.
Note: In RX Continuous mode only.