Comtech EF Data SNM-1000 User Manual
Page 54
SNM-1000 Node Control Modem
Revision 3
Operation
MN/SNM1000.IOM
3–12
3.4.1.2.10 DEMODULATOR:REACQUISITION
REACQUISITION
0 SECONDS
Displays the sweep reacquisition mode time duration. This is the time that the modem
will remain in a narrow sweep after loss of acquisition. After this timer runs out, the
modem will return to the normal acquisition sweep. The reacquisition time is 0 to 999
seconds. Default: 0 seconds.
3.4.1.3 CONFIGURATION:INTERFACE
CONFIGURATION
INTERFACE
3.4.1.3.1
INTERFACE:TX CLOCK SOURCE
TX CLOCK SOURCE
SCT (INTERNAL)
Programs the clock source for the modem transmitter clock to the following
configurations:
TX Terrestrial
Sets the TX clock to recover timing from the incoming clock/data.
SCT (INTERNAL)
Sets the TX clock to operate from the modem internal clock (this also is the
fallback clock).
Note: When loop timing is enabled, SCT (LOOP) is displayed instead of
SCT (INTERNAL).
EXT CLOCK
Sets the TX clock to operate from the EXT-CLK clock. Transmit clock source
must be phase/frequency locked to the data that is being transmitted. The
correct frequency must be programmed into EXT-CLK FREQ.
Upon entry, the current TX clock source is displayed. Press [
↑ ] or [↓ ] to make the
selection. Press