Comtech EF Data SNM-1000 User Manual
Page 161
SNM-1000 Node Control Modem
Revision 3
Remote Control Operation
MN/SNM1000.IOM
A–13
Modulator/
Coder Configuration
Program Status
Status:
Response:
MOM_xxxxxxx'cr'
MT_xxxx'cr'
MET_xxx'cr'
MF_nnn.nnnn'cr'
MR_nnnn_mmm.mmm'cr'
MPO_snn.n'cr'
MOP_snnn.n'cr'
SE_xxx'cr'
DENC_xxx'cr'
TDA_xxx'cr'
(Note 1)
TC_xxx'cr'
TCP_xxxx'cr'
BBL_xxx'cr'
RTSM_xxx'cr'
(Note 2)
TXM_xxxxx'cr' (Note
2)
MPRE_n'cr' (Note
2)
RSEN_xxx'cr' (Note
1)
RF_xxx'cr''lf']
Modem Operation Mode
Modulator Type
Modulator Encoder Type
Modulator Frequency
Modulator Rate
Modulator Power Offset
Modulator Output Power
Scrambler Enable (ON/OFF)
Differential Encoder (ON/OFF)
Transmit BPSK Data Ordering
Transmit Clock (Source)
Transmit Clock Phase
Baseband Loopback
RTS TX-IF Control Mode
Transmit Mode
Modulator Preamble
Reed-Solomon Encoder
RF Output (ON/OFF)
This command is used by the Comtech EF
Data M:N protection switch to collect
information necessary for configuring
backup modems.
Notes:
1. Status only returned in Transmit
Continuous mode.
2. Status only returned in Transmit
Burst mode.
Demodulator
Configuration Status
Status:
Response:
DF_nnn.nnnn'cr'
DR_nnnn_mmm.mmm'cr'
ADRA_nnnn_mmm.mmm'cr'
ADRB_nnnn_mmm.mmm'cr'
ADRC_nnnn_mmm.mmm'cr'
ADRD_nnnn_mmm.mmm'cr'
ADRV_nnnn.mmm.mmm'cr'
DE_xxx'cr'
DDEC_xxx'cr'
RFL_xxx'cr'
IFL_xxx'cr'
SCF_snnnnn'cr' (Note
1)
SWR_nnnnn'cr' (Note
1)
BERT_xxxx'cr'
DT_xxxx'cr'
DDT_xxx'cr'
RDA_xxx'cr' (Note
1)
RXM_xxxxx'cr'
RSDE_xxx'cr''lf'] (Note
1)
Demodulator Frequency
Demodulator Rate
Preset A Assignment
Preset B Assignment
Preset C Assignment
Preset D Assignment
Preset V Assignment
Descrambler Enable (ON/OFF)
Differential Decoder (ON/OFF)
RF Loopback (ON/OFF)
IF Loopback (ON/OFF)
Sweep Center Frequency
Sweep Width Range
BER Threshold
Demodulator Type
Demodulator Decoder Type
Receive BPSK Data Ordering
Receive Mode
Reed-Solomon Decoder
The demodulator configuration status
command causes a block of data to be
returned by the addressed modem. The
block of data reflects the current
configuration of the demodulator.
Notes:
1. Status only returned in Receive
Continuous mode.