Comtech EF Data SNM-1000 - Manual (Page 166)

SNM-1000 Node Control Modem Revision 3
Remote Control Operation MN/SNM1000.IOM
A–18
E
b
/N
0
Status Status:
Response:
MC EBN0_'cr'
EBN0_xnn.ndB'cr''lf']
Where:
x = < or > (data modifier to indicate that
the E
b
/N
0
is less than or greater than the
returned value).
nn.n = 1.0 to 99.9 (E
b
/N
0
value).
Notes:
1. The 'x' (< or >) parameter is only
returned if the E b /N 0 has exceeded
the computational resolution of the
system.
2. 'No Data' returned if the E b /N 0
cannot be calculated.
3. 'Sampling' returned if not enough
data available to calculate the E b /N 0.
Modulator Rate
Status
Status:
Response:
MC MR_'cr'
MR_nnnn_mmm.mmm'cr''lf']
Where:
In TX Burst mode, nnnn = 1/2 or 3/4
(Coder rate).
In TX Continuous mode,
nnnn = 1/2 (QPSK 1/2), [coder rate], 3/4
(QPSK 3/4), 7/8 (QPSK 7/8), BP12
(BPSK 1/2), 8P23 (8PSK 2/3), OQ12
(OQPSK 1/2), OQ34 (OQPSK 3/4),
OQ78 (OQPSK 7/8), OQSK (OQPSK
1/1), BPSK (BPSK 1/1) (QPSK (QPSK
1/1), 2144 (BPSK 21/44), B516 (BPSK
5/16), 8P34 (8PSK 3/4).
mmm.mmm = Data rate in kHz.
Demodulator Rate
Status
Status:
Response:
MC DR_'cr'
DR_nnnn_mmm.mmm'cr''lf']
Where:
In RX Continuous mode,
nnnn = 1/2 (QPSK 1/2), [coder rate], 3/4
(QPSK 3/4), 7/8 (QPSK 7/8), BP12
(BPSK 1/2), 8P23 (8PSK 2/3), OQ12
(OQPSK 1/2), OQ34 (OQPSK 3/4),
OQ78 (OQPSK 7/8), OQSK (OQPSK
1/1), BPSK (BPSK 1/1) (QPSK (QPSK
1/1), 2144 (BPSK 21/44), B516 (BPSK
5/16), 8P34 (8PSK 3/4).
mmm.mmm = Data rate in kHz.