Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 User Manual
Page 78

Page 77
270. Use a zip tie to hold the TPS extension
wiring to the MAF wiring.
271. Install the LPE-supplied hose with the
quick connect fitting (PN: EDL-15739-LPE) onto
the fitting in the air tube. Slide the other end of
the hose onto the barb fitting on the passenger-
side valve cover.
272. Using the supplied air filter template, make
a .700” hole in the air filter as shown. Drill the
hole in the location indicated by the arrow on
the driver side of the air filter. LPE recommends
using a stepped drill bit. Then install the supplied
90 degree fitting into the drilled hole.
NOTE: Be sure to remove all debris from inside
the air filter caused by drilling. This debris can
cause major engine damage if not removed.
273. Attach the inlet tube to the filter and
secure it with the supplied worm clamp. Lower
the supplied air filter and air inlet tube on to the
radiator shroud and tighten the air filter to the
air inlet tube using a clamp and an 8mm socket.
Install the AIR ( Air Induction Reaction) injection
hose on to the fitting shown by the yellow arrow.
The red arrow shows the hose that connects to it.