Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 - Manual (Page 40)

Page 39
119. Using a #40 Torx socket to hold the end
stud, tighten the nut with an 18mm wrench to re-
install the end-links. Torque the bolts to 35 ft-lbs.
120. Using a 6mm Allen tool and a 18mm
wrench, re-attach the tie rod ends to the the
control arm. Torque these nuts to 22 ft-lbs, then
rotate the nuts an additional 120 degrees.
CAUTION: The tie rod end nuts are designed
for one time use, so make sure to replace the
nuts during re-installation. Failure to do so could
result in the failure of the nut.
121. Re-attach the steering column to the gear
and install the bolt using an 11mm socket and
ratchet. Torque this bolt to 20 ft-lbs. Take care
not to move the steering wheel.
122. Re-install the exhaust H-pipe, support first
by locating and starting the six (6) nut positions
on the exhaust manifold (three nuts on each
side).
NOTE: Do not tighten the manifold nuts until after
the front hanger is re-installed.