Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 - Manual (Page 48)

Page 47
150. Locate the other red wire. This wire can
be cut to sufficient length when the Boost-A-
Pump is installed into the vehicle.
151. Strip the end of the same red wire roughly
3/8”. This wire will provide to output to the fuel
pump. Label the wire with tape to make sure that
the wires do not get switched when splicing the
Boost-A-Pump into the fuel pump circuit.
152. Cut the long black wire containing the
exposed black and red wires roughly five (5) feet
out of the Boost-A-Pump module.
153. Cut the black wire with the RCA jack 3-4
inches out of the Boost-A-Pump module.