Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 - Manual (Page 59)

Page 58
194. The intercooler will be mounted to the
lower radiator support from which the screw was
removed in step 192, denoted in the illustration
by the red arrow. Check to ensure that the exit
tube is facing upwards and that the pump inlet
barb is facing towards the rear of the vehicle.
195. Using the 90 degree hose (PN: 9820)
supplied in the LPE installation kit, trim the hose
to a sufficient length that allows the hose to
connect to both the water pump and the heat
exchanger. Install on the outlet of the water
pump to the heat exchanger. Use two (2) of
the supplied spring clamps from the E-force kit
to secure the hose to the water pump and heat
exchanger.
196. Using a 10mm deep socket, mount the
intercooler pump harness (PN: XX04468-0011)
ground wire to the stud using the factory nut.
Torque the nut to 65 in-lbs. The stud is located
on the frame in front of the passenger side wheel
well. Diagram 1 on page 84 illustrates the routing
of the various connectors of the intercooler pump
harness, which is described in steps 196-201.
197. Route the intercooler pump harness down
past the radiator and plug it in to the water pump.