Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 - Manual (Page 56)

Page 55
182. Using a drill, 1.5” hole saw, 1/4” drill bit,
and the supplied templates, drill out the 1.5”
hole and 0.25” hole on each side of the radiator
shroud. Each template is marked as to which side
it refers to. After the holes are bored out, remove
the burrs using a razor blade.
183. Using a metal cutting tool such as a
hacksaw or cut-off wheel, cut the heat exchanger
bracket shown in the illustration. Try to make the
cut as flush with the top of the heat exchanger as
possible. Take care not to damage the body of
the heat exchanger. Make sure to paint where
the bracket was removed to ensure that is sealed
from the elements.
184. Using blue Loctite®, install the heat
exchanger into the shroud with the bolts and
spacers provided. Steps 185-188 detail this
process.
185. Place the supplied aluminum spacers
between the shroud and the heat exchanger as
shown. There is one spacer for each side of the
exchanger.