Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 - Manual (Page 65)

Page 64
218. Connect the other end of the MAP/IAT
adaptor harness to the back of the supercharger.
Let the third connector of the MAP/IAT adaptor
harness hang at this time.
219. Install the vacuum line, whose other end
was connected in step 66, onto the nipple located
on the front driver side of the supercharger. The
yellow arrow denotes the vacuum line nipple,
while the red arrow denotes the brake booster
nipple which will be installed in the next step.
220. Using the supplied hose clamp, install
the brake booster hose onto the bigger nipple
adjacent to the smaller nipple in the last step.
221. Change the lower o-rings on the injectors
to the brown o-rings supplied in the LPE kit.
WARNING: The OEM injectors will not
provide enough fuel flow for the supercharger.
LPE recommends Siemens injectors (PN:
RXS107FM), which is pictured in the adjacent
illustration. If you are using any other injectors,
make sure that they have the correct O-ring
diameter or vacuum leaks may occur. Also, make
sure that the injectors are the correct length for
this application.