Lingenfelter L250280197 Lingenfelter C5 Corvette E-Force Supercharger Install Kit v2.9 - Manual (Page 50)

Page 49
158. Cut the middle wire on the pressure switch
electrical connection as shown by the yellow line
in the picture. Heat shrink the bare wire to cover
the exposed electrical copper.
159. Connect the two (2) stripped electrical
wires from the pressure switch electrical
connector to the red and black lines from the 5
foot wire. The wires can be hooked up in any
way to each other, polarity has no effect. LPE
recommends using the butt connectors provided
in the kit to connect them. Heat shrink the butt
connectors to ensure that the wires are secure.
Wrap the connections in electrical tape to ensure
that it is protected from the elements.
NOTE: The Boost-A-Pump module is now ready
to be installed into the vehicle.
160. Remove the two (2) retainers holding the
battery surround in by prying up on the center tab
with a flat head screwdriver or equivalent.
161. Remove the battery surround. This item
will not be re-installed.