Echelon i.LON SmartServer 2.0 - Manual (Page 354)

i.LON SmartServer 2.0 Programmer’s Reference 21-2
try
{
// See Section 20.2.1 (NET 3.5) or 20.2.2 (NET 2.0)for more information on iLON_SoapCalls class
SmartServerConsoleExample.iLON_SmartServer. E_xSelect xSelect =
new SmartServerConsoleExample.iLON_SmartServer. E_xSelect ();
xSelect.xSelect =
"//Item[@xsi:type=\"Dp_Cfg\"][contains(UCPTaliasName,\"nviClaValue\")]" ;
iLON_SmartServer. Item_Coll ItemColl = SmartServer.List(xSelect);
iLON_SmartServer. Item_DataColl ItemDataColl = SmartServer.Read(ItemColl);
if (ItemColl.UCPTfaultCount > 0)
{
Console .Out.WriteLine( "you've got errors" );
}
else
{
for ( int i = 0; i < ItemColl.Item.Length; i++)
{
iLON_SmartServer.
Item Dps = ItemColl.Item[i];
Console .Out.WriteLine(Dps.UCPTname);
iLON_SmartServer. Dp_Data DpValues =
(iLON_SmartServer. Dp_Data )ItemDataColl.Item[i];
Console .Out.WriteLine(DpValues.UCPTvalue[0].Value);
if (DpValues.UCPTvalue[0].Value == "0.0 0" )
{
DpValues.UCPTvalue[0].Value =
"100.0 1" ;
DpValues.UCPTvalue[1].Value = "ON" ;
Console .Out.WriteLine(DpValues.UCPTvalue[0].Value);
}
else if (DpValues.UCPTvalue[0].Value == "100.0 1" )
{
DpValues.UCPTvalue[0].Value =
"0.0 0" ;
DpValues.UCPTvalue[1].Value = "OFF" ;
Console .Out.WriteLine(DpValues.UCPTvalue[0].Value);
}
}
SmartServer.Write(ItemDataColl);
}
Console .ReadLine();
}
finally
{
iLON_SoapCalls .CloseBindingToSmartServer();
}
}
}
}
21.1.2 Creating and Reading a Data Logger in Visual C# .NET
The following C# console example creates a data logger and then reads the data recorded by it. You
can execute this code after you have referenced and inherited from the SmartServer WSDL as
described in section 20.1, and instantiated and initialized the Web service client as described in section
20.2.